Slate blue2/23/2023 Urethane Clear may be integrated into Urethane color. With Eastwood’s High Solids Urethane Clear as a basecoat/clearcoat system. This urethane paint may be applied as a stand-alone single-stage system, or in combination After 18 hours, paint should beĪbraded prior to re-coating for proper adhesion purposes. Re-coat anytimeĪfter the previous coat has flashed, or before 18 hours. Paint should beĭust free within 10-15 minutes and tack-free within one hour (at 70 ☏). A dry film thickness of approximately 2 mil is recommended. May be applied with metallic colors to help set an even flake pattern and /or adjust flake May be necessary to achieve total coverage for some metallic colors. HVLP Gun: Fluid Tip 1.3-1.5 mm Inlet Spray Pressure 25-30 psiĬonventional Gravity: Fluid Tip 1.3-1.6 mm Inlet Spray Pressure 45-50 psiĬonventional Siphon: Fluid Tip: 1.4-1.8 mm Inlet Spray Pressure 45-50 psiĪpply single-stage urethane paints in two to three medium wet coats as necessary toĪchieve sufficient coverage, allowing ten minute flash between coats. Use caution in mixing materials as Eastwood’s single-stage urethane paint may begin to gel after approximately two hours (at 70 ☏). No additional reduction is required but can be used as needed. Thoroughly mix three parts single-stage urethane paint with one part Activator. Pro Tip: When spraying Single Stage Metallic and Pearl Paints, you can improve appearance by using the special additive Metalli-Flow Metallic Paint Enhancer to help lock and stabilize metallic and pearl particles for a perfect finish.Eastwood's single-stage urethane paints hold their gloss longer and won't yellow. Superior to acrylic, alkyd and lacquer coatings. This premium 2-component topcoat system is blended with top-quality raw materials and advanced composition coatings technology. Max Temperature: Paint will handle up to 300 degrees without delamination, but color shift may occur, so it should not be used in a high heat setting.Makes 1 sprayable gallon when mixed 3:1 with a required activator.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |